AMCC 9000 manual To move legacy Jbod units under Windows

Moving Units from an 8000 Controller to a 9000 Controller

4Reboot the system and enter the 3ware 9000 series BIOS (3BM) by pressing Alt-3. Enable the Export JBOD policy on the Policy screen. (The next section in this guide, “Configuring Units”, describes how to work in 3BM. Additional information about 3BM is available in 3ware 9000 Series Serial ATA RAID Controller User Guide.)

5Press the F8 or Esc key to save and exit.

To move legacy JBOD units under Windows

1Install the 9000 controller in your system, while leaving the 8000 controller installed.

2Install the Windows driver. (For details, see “Driver Installation Under Windows” on page 53.)

3Power down the system, disconnect the drives from the 8000 controller and remove that controller from the system.

4Attach the drives to the 9000 board.

5Reboot the system and enter the 3ware 9000 series BIOS (3BM) by pressing Alt-3. Enable the Export JBOD policy on the Policy screen. (The next section in this guide, “Configuring Units”, describes how to work in 3BM. Additional information about 3BM is available in 3ware 9000 Series Serial ATA RAID Controller User Guide.)

6Press the F8 or Esc key to save and exit.

www.3ware.com 25