5.6. Parameter Expert (Optional Feature)
A Parameter Expert option can be purchased for the MAX 5000XL. The Parameter Expert (PE) assists a user through the development of a memory start. PE queries the user about his reference method, sets up a memory start, and walks the user through a series of tests to determine the highest acceptable test temperature. To speed development, tests are stopped if it looks like they will not end in a reasonable time; a higher test temperature will be tried instead. In the end, PE programs the memory start, which produces a fast and
accurate test. PE works on most samples up to 300°C. For ashing, PE sets up a memory start and runs a single test to determine the proper ending rate (if possible). Ashing may require more complex parameter development. Typical PE development time is < 2 hours for products < 25% moisture.
PE can be exited and reentered, and PE remembers the previous tests, so development will continue were it was previously stopped.
Develop From Scratch
The Parameter Expert is informative and guides the user through the steps.
∙NAME – This is used for the new memory start name.
∙REF METHOD TEMP – Enter the temperature used by the reference method. If temp > 300, then PE assumes ashing mode and sets up a memory start and runs a single test to determine the proper ending rate (if possible).
∙APPLICATION – Enter the application type, i.e. food, plastics, etc.
∙RESULT TYPE – Enter the result type output.
∙TARGET RESULT – Enter the reference method result.
∙FILTER PAPER – Liquids and creams may require filter paper to produce repeatable results. Because filter paper is expensive, try developing with “No” filter paper first.
AZI Customer Service | Page 58 of 92 |
