Brother FAX1 570MC, MFC 1970MC Remote Control Commands, Remote control commands Detail Operation

M E S S A G E C E N T E R 69

Remote Control Commands

Follow the commands below to access features remotely. When you call your FAX/ MFC and enter your Remote Access Code (The factory setting is 159), the system will signal you with two short beeps to enter a remote control command.

Remote control commands ■ Detail Operation

91Playing voice messages After one long beep, the FAX/MFC plays ICM and Memo.

1	(Skip back)	Press 1 while listening to an ICM or Memo message to play it
		again. If you press 1 before a message, you will hear the
		previous message.
2	(Skip next)	While playing ICM or Memo you can skip to next message.
9	STOP Playing	Stop playing the ICM or Memo.

92 Record Memo	After one long beep, you can record a memo. You can stop
	recording by pressing 9 .

93Erase all ICM & Memo If you hear one long beep, the erase is accepted. If you hear three short beeps, you cannot erase because all voice messages have not been played, or there is no voice message to erase. *This code erases all recorded messages, not one at a time.

94Play and Record OGM in memory

1	Play	1	MSG CTR OGM	The FAX/MFC plays the selected OGM. You can stop playing
		2	F/T OGM	OGMs by pressing 9 .
2	Record	1	MSG CTR OGM	After one long beep, you can record the selected OGM. You will
				hear the message played once. You can stop recording the
		2	F/T OGM
				message by pressing 9 .

95Changing Fax Forwarding/ If you hear one long beep, the change is accepted. If you hear

		Paging setting		three short beeps, you cannot change it because the conditions
		1	OFF	have not been met (Example: registering paging number). You
				can register your fax forwarding number by using 4. FAX FWD
		2	Fax Forwarding
				NO (See page 71). Once you have registered the number, the
				FAX/MFC will turn automatically to “FAXFWD:ON” mode. Then
		3	Paging
				retrieve a Memory Status List by entering 9 6 1 (See page
		4	FAX FWD NO.	70) to make sure the Fax Forwarding number you registered is
				correct in the List.
96 Retrieve Fax
	1		Memory Status List	Enter the number of a remote fax machine to receive a report or
	2		Retrieve all FAX	stored fax messages.
	3		Erase FAX in the	If you hear one long beep, you can erase the fax message from
			memory	the memory.

97Check the receiving status You can check whether your FAX/MFC has received any FAX or

1	FAX	VOICE messages. If yes, you will hear one long beep. If no, you
		will hear three short beeps.
2	VOICE

98Change Answer Mode If you hear one long beep, you can change the answer mode. If

	1	MSG CTR	you hear three short beeps, you cannot change it. (Example:
			There is no MSG CTR OGM when you want to change to MSG
	2	F/T
			CTR mode.)
	3	FAX
90 Exit			After a long beep, you can exit remote control.