Cabletron Systems CSMIM-T1 manual Restore Factory Defaults, Secondary Flow Control, Guard Tone

Commands

NOTE

Set %G1 first before setting %Fn.

&F	Restore Factory Defaults
	Restores factory default settings.
-Fn	Secondary Flow Control
-F0	Disables secondary flow control characters.
-F1	Enables secondary flow control characters.
	Controls whether the modem sends or receives secondary flow
	control characters on the serial port. When -F1is set and primary
	flow control enabled on the serial port, the modem sends two flow
	control characters (one primary and one secondary) to the host for
	flow control processing.
	If the modem receives either a primary or secondary XOFF flow
	control character, it stops sending data until it receives the
	corresponding primary or secondary XON character.
%Gn	Independent Serial-Port/Modem-Port Speed
%G0	Serial-port speed determines modem-port speed.
%G1	%B command determines modem-port speed.
	Determines whether the modem-port speed updates to match the
	serial-port speed with each AT command. When %G1 is set, the
	modem-port speed does not update, and you must change it with
	a %B or %Fn command.
&Gn	Guard Tone
&G0	Disables guard tone.
&G1	Sets guard tone on the answering modem to 550 Hz.
&G2	Sets guard tone on the answering modem to 1800 Hz.

CSMIM-T1 Hardware Installation Guide 7-15