Cabletron Systems CSMIM-T1 manual Error Description

BOOT Failures

The error count pinpoints the error that caused the boot failure. For example, if the boot failed during a Read Request due to excessive Expedited Remote Procedure Call (ERPC) layer errors, the Errors from Last ERPC Layer Invocation lists only errors that occurred during the failed Read Request (see Table 5-6). The report does not list errors that occurred during any other Read Request (see Table 5-7) or during the Open Request (see Table 5-8).

The Open Request and the Read Request layers communicate with the block file server (BFS) on the host. The ERPC layer resides below the Open Request and the Read Request layers. It is responsible for sending a given message to a specific host UDP port, and for receiving the correct response to that message from the port.

Table 5-6 Errors from Last ERPC Layer Invocation

Error	Description
H/W errors	The CSMIM-T1 sensed a hardware error during message
	transmission or reception. This error indicates a fault with the
	CSMIM-T1 LAN interface. Use the net command to isolate the
	problem.
Msgs from	The CSMIM-T1 received a message from an incorrect host.
wrong host	This indicates that the CSMIM-T1 received, and ignored, an
	unsolicited packet.
Rsp T/O’s	The CSMIM-T1 never received a correctly formatted response
	from the correct host, or any response from any load server
	hosts.
Msgs of wrong	The correct host sent a message to the CSMIM-T1, but the
type	message was not a correctly formatted response to the
	transmitted request.

CSMIM-T1 Hardware Installation Guide 5-11