Cabletron Systems CSMIM-T1 manual Chapter Modem Guide

Table of Contents

	5.3.1	Boot Error Report		5-10
	5.3.2	Correcting CSMIM-T1 Parameters		5-13
		5.3.2.1 Load Server Host Not Responding		5-14
		5.3.2.2 UNIX Host on the LAN		5-14
		5.3.2.3	Another CSMIM-T1	5-15
		5.3.2.4 VAX VMS Load Host on the LAN		5-16
5.4	CSMIM-T1 Dumps			5-17
CHAPTER 6		MODEM GUIDE
6.1	General			6-1
6.2	Features			6-2
6.3	Using the AT Command Set			6-3
	6.3.1 Key AT Command Factory Defaults			6-4
	6.3.2 Establishing 11-Bit Data Connections			6-5
	6.3.3 V.32bis Cellular Connections Using AT Commands			6-6
		6.3.3.1	Universal Cellular Setup	6-6

6.3.3.2MNP 10 V.32bis Quick Connect Cellular Only Setup6-6

6.4	Modulation Protocols		6-7
	6.4.1 Protocol Configuration Command Settings		6-10
	6.4.2 Speed and Protocol Connection Matrices		6-11
6.5	Error Correction		6-14
6.6	Diagnostics		6-16
	6.6.1	Power-Up Diagnostics	6-16
	6.6.2 Local Analog Loopback with Self-Test		6-16
	6.6.3	Local Analog Loopback	6-17
	6.6.4 Remote Digital Loopback with Self-Test		6-17
	6.6.5	Remote Digital Loopback	6-18
	6.6.6	Local Digital Loopback	6-18
	6.6.7 Respond to Remote Digital Loopback		6-19
	6.6.8 Automatically Terminating a Test: Register S18		6-19
6.7	Result Codes		6-20
	6.7.1 Connection Result Code Tables		6-20
CHAPTER 7		AT COMMANDS AND REGISTERS
7.1	The Command Set		7-1
	7.1.1	Entering Commands	7-1
		7.1.1.1 Issuing AT Commands at any Speed	7-2
7.2	Commands		7-2
	7.2.1 Operating Mode Dial Modifiers		7-9
7.3	Registers		7-41
	7.3.1 Commands to Change or Read Registers		7-41

CSMIM-T1 Hardware Installation Guide xi