Cabletron Systems CSMIM-T1 manual Parameter Descriptions

	Parameter Descriptions
Keyword	Description
tni_line_code	Sets or displays parameter setting as ami or b8zs. These
	values represent the line code used on the T1 Network
	Interface.
tni_ones_density	Sets or displays the T1 Network Interface ones density
	setting as on or off.
tdi_distance	Sets or displays an integer from 0 to 655 that represents
	the length of the cable from the T1 Drop/Insert Interface to
	the PBX or other equipment.
tdi_framing	Sets or displays the superframe format used on the T1
	Drop/Insert Interface as d4 (superframe) or esf (extended
	superframe). The default is esf.
tdi_line_code	Sets or displays the T1 Drop/Insert Interface line code
	setting as either ami or b8zs. The default is b8zs.

4.4PARAMETER DESCRIPTIONS

The CSMIM-T1 software comes with the following new parameters:

alarmsyslog

This T-1 parameter enables or disables the T-1 alarm event syslogs. A Y enables this parameter, an N disables it. The default is Y.

bypass

This T-1 parameter is used to remove the T-1 engine from the network. When bypass is set to Y, the T1 engine is off-line and the T1 Network Interface (T1NI) and the T1 Drop and Insert Interface (T1DII) are physically isolated from the T-1 engine. When bypass is set to Y, the T-1 engine has no effect on the T-1 circuit. When bypass is set to N, the T-1 engine is attached to both the T1NI and the T1DII. The default is Y.

CSMIM-T1 Hardware Installation Guide 4-9