Cabletron Systems CSMIM-T1 manual Execute the boot command see the boot command in Chapter

Chapter 2: INSTALLING THE CSMIM-T1

!

CAUTION

If you are loading software for the first time on a new unit, it is not necessary to erase the EEPROM. To do so will erase the EFS Key information, and you will have to reload it manually. If you have not recorded the key information and erase the EEPROM, you will have to call Cabletron Customer Service with your PO number to get a new one. For the reloading procedure, see Section 2.7.3 Reloading the EFS Key.

The erase command will also delete the LAT key, which is obtained separately from the EFS Key. Please make sure you have stored these keys in a safe place.

At the monitor prompt,

1.If necessary, execute the erase command to clear the EEPROM. (See the erase command in Chapter 3.)

2.Execute the addr command to enter CSMIM-T1 operating parameters described in Section 3.2, such as IP address, Ethernet address, Subnet Mask, Broadcast address, Preferred Load Host and Dump Host.

3.Execute the boot command (see the boot command in Chapter 3).

NOTE

The CSMIM-T1 takes 4 to 5 minutes for a normal boot over the network, depending on traffic.

If the boot is successful, then the following LED’s will be on:

•Modem Config LED’s (Green)

•STAT LED (Green)

•Ethernet Channel Indicator LED (Green)

•ON LINE LED (if T-1 line is connected)

If the boot is unsuccessful, the red ATTN LED will flash, and a message will display on the monitor.

2-14 CSMIM-T1 Hardware Installation Guide