Cabletron Systems CSMIM-T1 manual T-1 Parameters, Keyword Description

Chapter 4: CSMIM-T1 Parameters

4.3T-1 PARAMETERS

The CSMIM-T1 software comes with the following new T-1 parameters:

Keyword	Description
alarmsyslog	Sets or displays parameter setting as yes or no. These
	values enable or disable the alarm event syslogs.
bypass	Sets or displays parameter setting as yes or no. A setting
	of yes removes the T-1 engine from the network.
map	Sets or displays mappings for the DS0 channels.
ring	Sets or displays parameter setting as yes or no. A setting
	of yes means that an audible ring is sent to the service
	provider for incoming calls.
sigproto	Sets or displays the inbound and outbound signaling
	protocol settings for each DS0 channel.
t1_info	Sets or displays a character string (128 bytes maximum)
	of printable ASCII characters that describe installation
	information from the service provider.
tni_circuit_id	Sets or displays the T-1 circuit identifier string (128
	characters maximum) required by the service provider for
	customer service calls.
tni_clock	Sets or displays parameter setting as loop, local, or
	external. These values represent the source for the T-1
	clock.
tni_esf_fdl	Sets or displays parameter setting as ansi or att. These
	values represent the Facilities Data Link standard.
tni_framing	Sets or displays parameter setting as d4 or esf. These
	values represent the superframe format setting on the T1
	Network Interface.
tni_line_buildout	Sets or displays parameter setting as 0, 7.5, 15, or 22.5.
	These values represent the cable loss measurement
	between the last line generator and the customer location.

4-8 CSMIM-T1 Hardware Installation Guide