Cabletron Systems CSMIM-T1 manual S4=n Line Feed Character, S5=n Backspace Character

Registers

S4=n Line Feed Character

Range: 0 - 127, ASCII decimal

Default: 10 (line feed)

Sets the character recognized as a line feed. The line feed character follows the carriage return at the end of command lines and result codes.

The modem does not store this register with &W; enter *W to save it.

S5=n Backspace Character

Range: 0 - 32, ASCII decimal

Default: 8 (backspace)

Sets the character recognized as a backspace.

The modem does not store this register with &W; enter *W to save it.

S6=n Wait Before Dialing

Range: 2 - 255 seconds

Default: 2 seconds

Sets the length pause after off hook before the modem dials. The modem always pauses for a minimum of two seconds, even if S6 is set less than 2.

NOTE

Register S6 is valid only when either X0, X1, or X3 is set.

The modem does not store this register with &W; enter *W to save it.

S7=n Wait for Carrier After Dial

Range: 0 - 255 seconds

Default: 60 seconds

Sets the length of time that the modem waits for

•Carrier from remote modem before hanging up (originate or answer mode).

•Ring back (originate mode only, and only if either X3 or X4 is set).

•Dial tone when the “W” dial modifier is encountered in a dial string.

CSMIM-T1 Hardware Installation Guide 7-43