Cabletron Systems CSMIM-T1 manual INDEX-8

INDEX

repeat dial 7-11

repeat dial command 7-11 repeat last command 7-2 reset command 7-40

reset command reference 4-5reset modem 7-40

respond to loopback register 7-49respond to remote digital

loopback 6-19, 7-34 restore

factory default settings 7-40saved configuration settings 7-40

restore factory default settings 7-15result code form 7-35

result code register 7-45 result codes 6-20

extended 7-38 long/short 7-35 MNP 7-35 on/off 7-30

result codes, extended 7-38 result codes, longhort 7-35 retrain 7-13

retrain command 7-13 retrain sequence 7-27 retrain, begin 7-27

return to command state modifier 7-9ring

to auto-answer on 7-42 ring counter register 7-42 ring to auto-answer on 7-42 ROM Monitor

command syntax 3-1 commands 3-1

list of commands 3-1 RTS 7-32, 7-48, 7-50 RTS/CTS options 7-32

S

S registers, displaying 7-32

S registers, overview 7-41

S registers, read 7-32

saved configuration settings 7-37,7-40

secondary XOFF character 7-54 secondary XON character 7-54Self-booting2-15

sequence command 3-21 examples 3-21

Serial Devices 2-8,2-9 serial port

clear speed 7-34

flow control 7-25,7-30 speed 7-17

serial port bps rate 7-3

serial port DSR/CTS control 7-11 serial port parity command 7-28 serial port test 6-17,6-18

serial port, test 6-16serial-port DCD control 7-5 serial-port flow control 7-30 serial-port speed register 7-49serial-port speed, clear 7-34 serial-port, speed display 7-36 set command

reference 4-5setting

boot sequence 3-21 broadcast address 3-5 Internet address 3-4 IP encapsulation 3-5 load/dump gateway address 3-5preferred load host address 3-5SLIP parameters 3-22

subnet mask 3-5

setting protocols by commands 6-10 settings, read current 7-33

short form result codes 7-35 show command reference 4-5 single cellular connection 7-7

SLIP parameters 3-23

slip command 3-22 example 3-24

INDEX-8 CSMIM-T1 Hardware Installation Guide