Commands

Table 3-2 . The slip Command Prompts

PromptDescription

Modifies the port’s mode. Ay response changes the port to a SLIP interface. An n response changes

Allow SLIP on this port the port’s mode to CLI. The port is not available as a SLIP interface and the SLIP parameters are ignored. The default is n.

Enter local endpoint address

Enter remote endpoint address

Enter remote load/dump host address

Should this interface be used for memory dumps

Enter the baud rate

Enter the number of stop bits

Enter the parity

Specifies the CSMIM-T1 IP address for this SLIP interface. The CSMIM-T1 boots over the SLIP interface only if this address is set.

Specifies the IP address of the remote end of the SLIP interface.

Specifies the IP address of the remote host to which load and dump requests are sent. This address is required only if the remote host is a gateway and not the load host. By default, this is the same as the remote end-point address.

Enables the CSMIM-T1 to use a SLIP interface for memory dumps. The default is y.

Specifies the baud rate of the serial interface. The default is 9600.

Pressing the RETURN key accepts the default (one). Generally, SLIP implementations require the default.

Pressing the RETURN key accepts the default (none). Generally, SLIP implementations require the default.

CSMIM-T1 Hardware Installation Guide

3-23

Page 65
Image 65
Cabletron Systems CSMIM-T1 manual Slip Command Prompts