Cabletron Systems CSMIM-T1 manual T7=n Timer for False Answer Abort

Registers

:T7=n Timer for False Answer Abort

Where n is an integer from 0 to 255, representing seconds. Default n=60 seconds; setting :T7=0 disables this timer.

This command takes effect only when the modem falls back to a normal mode V.23 half-duplex connection.

Sets the amount of time the modem waits before hanging up when it receives no data. If this command is set to a value greater than zero, the timer starts when the modem connects. If the modem does not receive data in the specified time, it hangs up.

:T9=n Primary XON Flow Control Character

NOTE

Where n is a decimal from 0 to 255, representing an 8-bit character. Default n=11 hexadecimal (or 17 decimal) <DC1>. Defines the character used for primary XON flow control on the modem and serial ports. Enable primary flow control with \Q1, \Q4, \G1, or \G2.

With modem-port flow control, both modems must have the same primary flow control characters set during normal connections.

:T10=n Primary XOFF Flow Control Character

Where n is a decimal from 0 to 255, representing an 8-bit character. Default is 13 hexadecimal (or 19 decimal) <DC3>. Defines the character used for primary XOFF flow control on the modem and serial ports. Enable primary flow control with \Q1, \Q4, \G1, or \G2.

CSMIM-T1 Hardware Installation Guide 7-53