Cabletron Systems CSMIM-T1 manual ATD 011225551234 Enter, Dial Modifiers, H2 command

Commands

D <dial string> Dial

Where <dial string> is a string of up to 98 characters. Do not type

<or >.Valid dial string characters are: 0-9, dial modifiers, and for tone dialing A, B, C, D, #, and*. The modem ignores invalid characters. Dial strings longer than 98 characters produce an error message.

Dials a telephone number and attempts to establish a connection. The Dial command must be the last one on a command line.

To cancel the Dial command, press any key or use your data communications software to lower DTR (unless &D0 is set).

To dial the telephone number 011 22 555 1234, type:

ATD 011225551234 <Enter>

NOTE

After disconnect, there is a 5-second delay before the modem goes off hook in originate mode.

Dial Modifiers

	Dial modifiers allow you to add conditions to the telephone
	number you dial. You can use several modifiers with the same
	telephone number. Dial modifiers include:
^A	(Link Negotiation) Perform link negotiation at 4,800 bps for the
	current connection only. (This dial modifier is equivalent to the
	*H2 command.)

J(Link Negotiation) Perform link negotiation at 1,200 bps for the current connection only. (This dial modifier is equivalent to the *H1 command.)

K(Cell-Side Cellular Connection) Sets )M1 for the current connection only.

P(Pulse Dial) Placed anywhere in the dial string, causes the modem to pulse dial. For example: ATD P5551234 <Enter>.

CSMIM-T1 Hardware Installation Guide 7-7