3
Mount the seat and handlebar.
Small screw | Spring washer |
¥Mount the seat to the seat pipe using the large screws and the handlebar using the small ones.
Flat washer
Large screw
Seat
Spring washer
4
Assemble the rear frame.
¥Loosen and remove the seat height lock knob.
¥Insert the rear support pipe into the socket of seat pipe. Select any height and tighten the knob.
Flat washer
Handlebar
Seat height lock knob
Rear support pipe
5 | Connect the Inner pipe. |
¥ First, connect the pulse sensor cables. |
Caution: If the connection is incomplete, the pulse rate will not be displayed. Be sure to fully insert the connector.
¥ Insert the front end of the inner pipe into the joint of the main unit and fasten it securely with the two screws and the grip.
Caution: ¥ To prevent the connected cord from becoming slack, bundle the cords into the inner pipe. If the pipe is inserted though the cord is not taut, the cord may get caught, result in disconnection.
¥When removing the inner pipe, ensure that two persons carry out this task. When removing the in- ner pipe, the pulse sensor cord may be pulled acci- dentally resulting in disconnection.
Grip |
Screws |
Joint fitting |
Inner pipe |
Pulse sensor cable |
Excess |
Fold
8
