show controllers cable-modem mac
COS 1: |
|
|
Assigned SID: | 5 |
|
Max Downstream Rate: | 4000000 | |
Max Upstream Rate: | 2000000 | |
Upstream Priority: | 7 |
|
Min Upstream Rate: | 100000 | |
Max Upstream Burst: | 12 |
|
Privacy Enable: | TRUE | |
Ranging Backoff Start: | 0 | (at initial ranging) |
Ranging Backoff End: | 4 | (at initial ranging) |
Data Backoff Start: | 0 | (at initial ranging) |
Data Backoff End: | 4 | (at initial ranging) |
IP Address: | 0.0.0.0 | |
Net Mask: | 0.0.0.0 | |
TFTP Server IP Address: | 223.255.254.254 | |
Time Server IP Address: | 188.188.1.5 | |
Config File Name: | muck/ebuell/tftp/cm_conf | |
Time Zone Offset: | ||
Table 12 describes the fields shown in the display.
Table 12 show controllers cable-modem MAC State Field Descriptions
Field | Description |
MAC State | Current operational state of the MAC layer of the Cisco uBR900 series. |
|
|
Ranging SID | Service ID used for ranging requests. |
|
|
Registered | Indicates whether or not the Cisco uBR900 is currently registered with the CMTS. |
|
|
Privacy Established | Indicates whether or not keys for baseline privacy have been exchanged between the |
| Cisco uBR900 series and the CMTS, establishing privacy. |
|
|
Mac Resets | Number of times the Cisco uBR900 series reset or initialized this interface. |
|
|
Sync lost | Number of times the Cisco uBR900 series lost synchronization with the downstream |
| channel. |
|
|
Invalid Maps | Number of times the Cisco uBR900 series received invalid MAP messages. |
|
|
Invalid UCDs | Number of times the Cisco uBR900 series received invalid UCD messages. |
|
|
Invalid Rng Rsp | Number of times the Cisco uBR900 series received invalid ranging response |
| messages. |
|
|
Invalid Reg Rsp | Number of times the Cisco uBR900 series received invalid registration response |
| messages. |
|
|
T1 Timeouts | Number of timeouts caused by the Cisco uBR900 series not receiving a valid |
| upstream channel descriptor (UCD) from the CMTS within the specified time. |
|
|
T2 Timeouts | Number of timeouts caused by the Cisco uBR900 series not receiving a maintenance |
| broadcast for ranging opportunities from the CMTS within a specified time. |
|
|
T3 Timeouts | Number of timeouts caused by the Cisco uBR900 series not receiving a response |
| within a specified time from the CMTS to a |
| maintenance. |
|
|
T4 Timeouts | Number of timeouts caused by the Cisco uBR900 series not receiving a response |
| within a specified time from the CMTS to a periodic maintenance request. |
|
|
Range Aborts | Number of times the ranging process was aborted by the CMTS. |
|
|
DS ID | Identifier of the downstream channel on which this MAC management message has |
| been transmitted. This identifier is arbitrarily chosen by the CMTS and is only |
| unique within the |
|
|
Configuring the Cisco uBR900 Series Cable Access Routers 99
