Cisco Systems UBR900 specifications Cable-modem compliant bridge

cable-modem compliant bridge

cable-modem compliant bridge

To enable DOCSIS-compliant transparent bridging for a cable access router interface at startup, use the cable-modem compliant command from interface configuration mode. Use the no form of this command to disable DOCSIS-compliant bridging for the interface.

cable-modem compliant bridge

no cable-modem compliant bridge

Syntax Description

This command has no arguments or keywords.

Defaults

Enabled

Command Modes

Interface configuration

Command History

ReleaseModification

11.3 NA This command was introduced.

Usage Guidelines

It is normally not necessary to enter this command in data-over-cable bridging applications because DOCSIS-compliant bridging is enabled by default. If you wish to do full transparent bridging rather than DOCSIS-compliant bridging, use the no form of the command, then configure full transparent bridging using CLI commands. See the “Configuring Bridging” section on page 41 for instructions.

Examples

The following example shows how to enter the cable-modem compliant bridge command for a cable access router interface, starting from global configuration mode:

uBR924(config)# interface cable-modem 0

uBR924(config-if)#cable-modem compliant bridge

uBR924(config-if)#

Configuring the Cisco uBR900 Series Cable Access Routers 57