Compaq AA-RHGWB-TE manual ATM Switch Indicator Comments, Phy

#/usr/sbin/setld -i grep ATM

•OSFATMBASE: ATM Commands

•OSFATMBIN: ATM Kernel Modules

Additionally, after the ATM subsets have been installed, verify that a new kernel has been built with the following kernel options selected (/sbin/sysconfig -q atm):

•Asynchronous Transfer Mode (ATM)

•ATM UNI 3.0/3.1 Signalling for SVCs

•LAN Emulation over ATM (LANE)

3.Enable the ATM driver with the following command:

# /usr/sbin/atmconfig up driver=driver_name

In the command, driver_name is lta# for the ATMworks 350. The number sign (#) is the adapter number.

To enable lta0 to initiate contact with the network, enter the following command:

# /usr/sbin/atmconfig up driver=lta0

4.Check the ATM switch for an indication that it is receiving idle cells. The following table provides the indication for a few ATM switches. If you do not have one of these switches, check the documentation for your switch to determine how the switch indicates that it is cabled correctly.

ATM Switch	Indicator	Comments
Compaq GIGAswitch	PHY	Illuminated green LED indicates
		that the switch is receiving idle
		cells from the ATM adapter.
Bay Networks®	En	Illuminated green LED indicates
Centillion100		that the switch is receiving idle
		cells from the ATM adapter.
SynOptics® LattisCell	Link	Illuminated green LED indicates
10114		that the switch is receiving idle
		cells from the ATM adapter.
CISCO® Systems	TX	The switch starts transmitting
LightStream 1010		data as soon as it receives idle
		cells. The green TX LED will
		flash on and off.
FORESystems®	TX	The Yellow TX LED will
ForeRunner A S X200		be on steady.

Preparing ATM Adapters 7–5