1Use the CONFIG utility to configure the devices on the device side buses
and add them to the controller configuration. The CONFIG utility takes
about two minutes to complete. You can use the ADD DISK command to
add disk drives to the configuration manually.
2Create the BOOT-MIR mirrorset using disks 30200 and 30300 and the
CROOT-MIR mirrorset using disks 40000 and 40100.
3Initialize the BOOT-MIR and CROOT-MIR mirrorsets. If you want to set
any initialization switches, you must do so in this step. TheBOOT-MIR
mirrorset will be used for the Tru64 UNIX and cluster member system
boot disks. The CROOT-MIR mirrorset will be used for the cluster root
(/), cluster /usr and cluster /var file systems, and the quorum disk.
4Verifythe mirrorset configurationand switches. Ensure that the
mirrorsets use the correct disks.
5Create appropriate sized partitions in the BOOT-MIR mirrorset using
the percentage of the storageset that each partition will use. These
partitions will be used for the two member system boot disks (25 percent
or 1 GB each) and the Tru64 UNIX disk. For the last partition, the
controller assignsthe largestfree space available to the partition (which
will be close to 50 percent or 2 GB).
6Create appropriate sized partitions in the CROOT-MIR mirrorset using
the percentage of the storageset that each partition will use. These
partitions will be used for the quorum disk (5 percent), cluster root
partition (15 percent), /usr (40 percent), and /var file systems. For
the last partition, /var, the controller assigns the largest free space
available to the partition (which will be close to 40 percent). See the
TruClusterServer Software Installationmanual to obtain partition
sizes.
7Verifythe BOOT-MIR mirrorset partitions. Ensure that the partitions
are of the desired size. The partition number is in the first column,
followed by the partition size and starting block.
8Partition for member system 1 boot disk.
9Partition for member system 2 boot disk.
10 Partition for Tru64 UNIX operating system disk.
11 Verifythe CROOT-MIR mirrorset partitions. Ensurethat the partitions
are of the desired size. The partition number is in the first column,
followed by the partition size and starting block.
12 Partition for the quorum disk.
13 Partition for cluster root (/) filesystem.
6–38 Using Fibre Channel Storage