Compaq AA-RHGWB-TE manual Scsi ID

Table 8–4: TL894 Default SCSI ID Settings (cont.)

SCSI Device	SCSI Address
Tape Drive 2	4
Tape Drive 3	5

To set the SCSI ID for the TL894 robotics controller, follow these steps:

1.Press and release the Control Panel STANDBY button and verify that the SDA (Status Display Area) shows System Off-line.

2.Press and release SELECT to enter the menu mode.

3.Verify that the following information is displayed in the SDA:

Menu:

Configuration:

4.Press and release SELECT to choose the Configuration menu.

5.Verify that the following information is displayed in the SDA:

Menu: Configuration Inquiry

6.Press and release the up or down arrow buttons to locate the SCSI Address submenu, and verify that the following information is displayed in the SDA:

Menu: Configuration SCSI Address ..

7.Press and release the SELECT button to choose the SCSI Address submenu and verify that the following information is displayed in the SDA:

Menu: Configuration Robotics

8.Press and release the SELECT button to choose the Robotics submenu and verify that the following information is displayed in the SDA:

Menu: SCSI Address

SCSI ID 0

9.Use the up and down arrow buttons to select the desired SCSI ID for the robotics controller.

10.When the desired SCSI ID is displayed on line 2, press and release the SELECT button.

11.Press and release the up or down button to clear the resulting display from the command.

Configuring a Shared SCSI Bus for Tape Drive Use 8–31