Compaq AA-RHGWB-TE manual Configuring TruCluster Server Hardware, Step Action Refer to

______________________ Note _______________________

The KZPSA-BB can be used in any configuration in place of the KZPBA-CB. The use of the KZPSA-BB is not mentioned in this chapter because it is not UltraSCSI hardware, and it cannot operate at UltraSCSI speeds.

The use of the KZPSA-BB (and the KZPBA-CB) with external termination is covered in Chapter 10.

It is assumed that when you start to install the hardware necessary to create a TruCluster Server configuration, you have sufficient storage to install the TruCluster Server software, and that you have set up any RAID storagesets.

Follow the steps in Table 4–2 to start the procedure for TruCluster Server hardware installation. You can save time by installing the Memory Channel adapters, redundant network adapters (if applicable), and KZPBA-CB SCSI adapters all at the same time.

Follow the directions in the referenced documentation, or the steps in the referenced tables, returning to the appropriate table when you have completed the steps in the referenced table.

_____________________ Caution _____________________

Static electricity can damage modules and electronic components. We recommend using a grounded antistatic wrist strap and a grounded work surface when handling modules.

Table 4–2: Configuring TruCluster Server Hardware

Step	Action	Refer to:
1	Install the Memory Channel module(s),	Chapter 5a
	cables, and hub(s) (if a hub is required).

2Install Ethernet or FDDI network adapters.

User’s guide for the applicable Ethernet or FDDI adapter, and the user’s guide for the applicable system

	Install ATM adapters if using ATM.	Chapter 7 and ATMworks 350
		Adapter Installation and Service
3	Install a KZPBA-CB UltraSCSI adapter	Section 4.3.1 and Table 4–3
	for each radially connected shared SCSI
	bus in each member system.

4–6TruCluster Server System Configuration Using UltraSCSI Hardware