Compaq AA-RHGWB-TE manual Displaying KZPBA-CB Adapters with the show Console Commands

Table 4–3: Installing the KZPBA-CB for Radial Connection to a DWZZH UltraSCSI Hub (cont.)

Step Action	Refer to:
_____________________ Notes	_____________________

6

7

Ensure that the SCSI ID that you use is distinct from all other SCSI IDs on the same shared SCSI bus. If you do not remember the other SCSI IDs, or do not have them recorded, you must determine these SCSI IDs. If you are using a DS-DWZZH-05, you cannot use SCSI ID 7

for a KZPBA-CB UltraSCSI adapter; SCSI ID 7 is reserved for DS-DWZZH-05 use.

If you are using a DS-DWZZH-05 and fair arbitration is enabled, you must use the SCSI ID assigned to the hub port the adapter is connected to.

You will have problems if you have two or more SCSI adapters at the same SCSI ID on any one SCSI bus.

Repeat steps 1 through 6 for any other KZPBA-CBs to be installed on this shared SCSI bus on other member systems.

Connect a DS-DWZZH-03 or DS-DWZZH-05	Section 3.6
UltraSCSI hub to an:
HSZ70 or HSZ80 in transparent failover mode	Section 3.7.1.1
HSZ70 or HSZ80 in multiple-bus failover mode	Section 3.7.1.2

4.3.2Displaying KZPBA-CB Adapters with the show Console Commands

Use the show config and show device console commands to display system configuration. Use the output to determine which devices are KZPBA-CBs, and to determine their SCSI bus IDs.

Example 4–1 shows the output from the show config console command on an AlphaServer DS20 system.

Example 4–1: Displaying Configuration on an AlphaServer DS20

P00>>> show config

	AlphaServer DS20 500 MHz
SRM Console:	T5.4-15
PALcode:	OpenVMS PALcode V1.54-43, Tru64 UNIX PALcode V1.49-45
Processors
CPU 0	Alpha 21264-4 500 MHz	SROM Revision: V1.82
	Bcache size: 4 MB
CPU 1	Alpha 21264-4 500 MHz	SROM Revision: V1.82
	Bcache size: 4 MB

4–10TruCluster Server System Configuration Using UltraSCSI Hardware