If you are setting up a redundant Memory Channel configuration, install the second Memory Channel adapter right after installing the first Memory Channel adapter. Ensure that the jumpers are correct and are the same on both modules.
After you install the Memory Channel adapter(s), replace the system panels unless you have more hardware to install.
5.3Installing the MC2 Optical Converter in the Member System
If you are going to use a CCMFB optical converter along with the MC2 PCI adapter, install it at the same time that you install the MC2 CCMAB. To install a MC2 CCMFB optical converter in the member system, follow these steps. See Section 5.5.2.4 if you are installing an optical converter in an MC2 hub.
1.Remove the bulkhead blanking plate for the desired PCI slot.
2.Thread one end of the fiber optics cable (BN34R) through the PCI bulkhead slot.
3.Thread the optics cable through the slot in the optical converter module (CCMFB) endplate (at the top of the endplate).
4.Remove the cable tip protectors and attach the keyed plug to the connector on the optical converter module.
5.Seat the optical converter module firmly into the PCI backplane and secure the module with the PCI card cage mounting screw.
6.Attach the
7.Route the fiber optics cable to the remote system or hub.
8.Repeat steps 1 through 7 for the optical converter on the second system. See Section 5.5.2.4 if you are installing an optical converter in an MC2 hub.
5.4Installing the Memory Channel Hub
You may use a hub in a
•For use with the MC1 or MC1.5 CCMAA adapter, you must install the hub within 10 meters of each of the systems.
