12.Press and release the up or down button and the SELECT button simultaneously, and verify that System
To set the SCSI ID for each tape drive if the desired SCSI IDs are different from those shown in Table
1.Press and release the Control Panel STANDBY button and verify that the SDA (Status Display Area) shows System
2.Press and release SELECT to enter the menu mode.
3.Verify that the following information is displayed in the SDA:
Menu:
Configuration:
4.Press and release SELECT to choose the Configuration menu.
5.Verify that the following information is displayed in the SDA:
Menu: Configuration SCSI Address
6.Press and release the SELECT button again to choose SCSI Address and verify that the following information is shown in the SDA:
Menu: SCSI Address Robotics
7.Use the down arrow button to bypass the Robotics submenu and verify that the following information is shown in the SDA:
Menu: SCSI Address Drive 0
8.Use the up and down arrow buttons to select the drive number to set or change.
9.When you have the proper drive number displayed on line 2, press and release the SELECT button and verify that the following information is shown in the SDA:
Menu: Drive 0
SCSI ID 0
10.Use the up and down arrow buttons to select the desired SCSI ID for the selected drive.
11.When the desired SCSI ID is displayed on line 2, press and release the SELECT button.
12.Repeat steps 8 through 11 to set or change all other tape drive SCSI IDs.
13.Press and release the up or down button to clear the resulting display from the command.
