5.11 LED Board
LED Board
Spare Part Number Information
LED board |
|
used with all config. codes except those beginning | |
with FL5, FL6, FM, FV, FW, and JF. |
|
used with all config. codes beginning with FL5, | |
FL6, FM, FV, FW, and JF. |
|
Removing the LED Board
1.Prepare the computer for disassembly (Section 5.3)
2.Remove the switch cover (Section 5.9).
3.Disconnect the display ground cables (Section 5.9) and RTC battery cable (Section 5.10) from the LED board.
4.Remove the screw 1 that secures the LED board to the system board (Figure
5.Lift up on the right side of the LED board 2 to disconnect it from the system board.
Figure 5-17. Removing the LED Board
NOTE: There are two LED boards used on the Compaq Armada E500 Series of Personal Computers. The LED board that contains the Easy Access buttons 3 is not used with all computer models. Refer to the LED board spare part number information at the top of this page to determine which models use this LED board.
6. Remove the LED board.
Reverse the removal procedures to replace the LED board.
