Datalogic Scanning 7000 manual Imgsnp Modifiers

Imaging Commands

IMGSNP Modifiers

P - Imaging Style: Sets the Image Snap style.

0P Decoding Style. This is similar to the current format for decoding, however, this processing allows a few frames to be taken until the exposure parameters are met. Then the last frame is available for further use.

1P Photo Style (default). This attempts to mimic a simple digital cam- era, and results in a visually optimized image.

2P Manual Style. This is an advanced style, and should not normally be used. It allows you the most freedom to set up the imager, and has no auto-exposure.

B - Beeper: Causes a beep to sound after an image is snapped.

0B No beep (default)

1B Sounds a beep when the image is captured, notifying the user that the imager can be moved.

E - Exposure: This allows you to set the exposure time. Units are 127 microseconds. Exposure is used in Manual Style only. (Default = 7874)

nE Range: 0 - 7874

G - Gain: This modifier boosts the signal and multiplies the pixel value.

1G No gain (default)

2G Medium gain

4G Heavy gain

8G Maximum gain

D - Delta for Acceptance: This sets the allowable range for the white value setting (see W - Target White Value). Delta is only available when using Photo Style. (Default = 25)

7-2 PowerScan® 7000 2D