Output

LED Power Level

This selection allows you to adjust LED and aimer brightness. Off is used when no illumination is needed. Low is used if low illumination is sufficient. High (the default) is the brightest setting.

If you have an aimer delay programmed (see Aimer Delay on page 3-12), the aimer will be at 100% power during the delay, regardless of the LED Power Level.

If you scan the Off bar code, both the aimer and illumination lights turn off, making it impossible to scan bar codes in low light. To turn the LED Power Level back on, move to a brightly lit area

NOTE and scan either the Low or the High bar code below.

Off

Low (50%)

*High (100%)

3-10

PowerScan® 7000 2D

Page 40
Image 40
Datalogic Scanning 7000 manual LED Power Level, Off Low 50% High 100%