Output
3-4 PowerScan® 7000 2D
Good Read Delay
This sets the minimum amount of time before the imager can read
another bar code. Default = No Delay.
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar
code below, then set the delay (from 0-30,000 milliseconds) by scanning
digits from the Programming Chart on page B-5, then scanning Save.
Trigger Modes

Manual/Serial Trigger

You can activate the imager either by pressing the trigger, or using a serial
trigger command (see Trigger Commands on page10-5). When in man-
ual trigger mode, the imager scans until a bar code is read, or until the
trigger is released.
*No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay