Datalogic Scanning 7000 manual Illumination Lights, Imager Time-Out, Lights On Lights Off

Illumination Lights

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights On bar code, below. However, if you want to turn just the lights off, scan the Lights Off bar code.

This setting does not affect the aimer light. The aiming light can be set using Aimer Mode (see Aimer Modes on page 3-13).

NOTE

* Lights On

Lights Off

Imager Time-Out

Imager Time-Out powers down the imager after the unit has been idle for the specified time. To prevent the imager from powering down, set this time-out to 0. Scan the bar code below, then set the time-out by scanning digits (from 0 - 999,999 ms) from the Programming Chart on page B-5, then scanning Save. Default = 120,000 ms.

Imager Time-Out

Product Reference Guide 3-11