Datalogic Scanning 7000 manual Terminal ID, Faces

Chapter 2

Terminal Interfaces

	Use this section to configure interface features
	for imager models using RS-232 and USB inter-
	faces.
NOTE	For Imager models using UKBW interfaces, do
	not use this section but refer to the UKBW Con-
	nectivity Guide available for download from the
	website listed on the back over of this manual.
	In most cases and mainly in Concurrent Aiming
	mode an external power supply is required.

Terminal ID

If your interface is not a standard PC AT, refer to Supported Terminals on page 2-2, and locate the Terminal ID number for your PC. Scan the Ter- minal ID bar code below, then scan the numeric bar code(s) on the Pro- gramming Chart on page B-5of this manual to program the Imager for your terminal ID. Scan Save to save your selection.

Product Reference Guide 2-1