Datalogic Scanning 7000 manual Code 39 Check Character, Code 39 Message Length

Symbologies

Code 39 Check Character

No Check Character indicates that the imager reads and transmits bar code data with or without a check character.

When Check Character is set to Validate, but Don’t Transmit, the unit only reads Code 39 bar codes printed with a check character, but will not transmit the check character with the scanned data.

When Check Character is set to Validate and Transmit, the imager only reads Code 39 bar codes printed with a check character, and will trans- mit this character at the end of the scanned data. Default = No Check Character.

* No Check Character

Validate, but Don’t Transmit

Validate and Transmit

Code 39 Message Length

Scan the bar codes below to change the message length. Refer to Mes- sage Length Description on page 6-2 for additional information. Mini- mum and Maximum lengths = 0-48. Minimum Default = 0, Maximum Default = 48.

Minimum Message Length

Maximum Message Length

6-6 PowerScan® 7000 2D