Datalogic Scanning 7000 manual Multiple Symbols, No Read

Data Formatter

Output

Multiple Symbols

This feature does not work when the Imager is in Low Power mode.

NOTE

When this programming selection is turned On, it allows you to read multiple symbols with a single pull of the Imager’s trigger. If you press and hold the trigger, aiming the Imager at a series of symbols, it reads unique symbols once, beeping (if turned on) for each read. The imager attempts to find and decode new symbols as long as the trigger is pulled. When this programming selection is turned Off, the Imager will only read the symbol closest to the aiming beam.

On

* Off

No Read

With No Read turned On, the Imager notifies you if a code cannot be read. If using a PowerView Scan Data Window, an “NR” appears when a code cannot be read. If No Read is turned Off, the “NR” will not appear.

On

* Off

If you want a different notation than “NR,” for example, “Error,” or “Bad Code,” you can edit the output message using the

on page 5-5. The hex code for the No Read symbol is 9C.

3-22 PowerScan® 7000 2D