Datalogic Scanning 7000 manual User-Specified Aimer Delay, Milliseconds, Delay Duration

Output

Aimer Delay

The aimer delay allows a delay time for the operator to aim the imager before the picture is taken. Use these codes to set the time between when the trigger is pulled and when the picture is taken. During the delay time, the aiming light will appear, but the LEDs won’t turn on until the delay time is over.

200 milliseconds

400 milliseconds

*Off (no delay)

User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning digits (0 - 4,000 ms) from the Programming Chart on page B-5of this manual, then scan Save.

Delay Duration

3-12 PowerScan® 7000 2D