rw — Specifies read-write access

su — Specifies SNMP administrator access

ipv4-address— Management station IPv4 address. Default is all IP addresses.

Parameters range

community — 1 - 20 chars

ip-address— Valid IP address

Default

No community is defined

Command Mode

Global configuration

Usage Guidelines

The logical key of the command is the pair (community, ip-address). If ip-address is omitted then the key is (community, All-Ips).

Examples

Switch(conf)# snmp-server community public

Command: username

To establish a username-based authentication system, use the username command in global configuration mode. Use the no form to remove a user name.

username name [password password] [level level] [encrypted] no username name

Syntax Description

name — The name of the user.

password — The authentication password for the user.

level — Specifies the user level. If not specified the privilege level is 1.

encrypted — Encrypted password you enter, copied from another device configuration.

Parameters range

name — 1 - 20 characters.

password — 1 - 159

level — 1 - 15

Dell PowerConnect 28xx Systems User Guide

167

Page 167
Image 167
Dell 28XX manual Command username, Default, 167