Dell 28XX manual 104, LAG Configuration

LAGs can be configured according to the following load balancing types: Layer 2, Layer 2 and Layer 3 or Layer 3.

The LAG Configuration page contains fields for configuring parameters for configured LAGs. The device supports up to eight LAGs, and each LAG can have up to eight members.

For information about

To open the LAG Configuration page, click Switch→ Ports→ LAG Configuration in the tree view.

If port configuration is modified while the port is a LAG member, the configuration change is only effective after the port is removed from the LAG.

Figure 7-9. LAG Configuration

The LAG Configuration page contains the following fields:

•Load Balance — Indicates the load balancing type enabled on the LAG. The possible field values are:

–Layer 2 — Enables load balancing based on static and dynamic MAC addresses.

–Layer 3 — Enables load balancing based on source and destination IP addresses.

–Layer 2-3— Enables load balancing based on static and dynamic MAC addresses, and source and destination IP addresses.

•LAG — The LAG number.

•LAG Mode — Indicates that the LAG mode is static.

104

Dell PowerConnect 28xx Systems User Guide