
–Use Saved IP/User Name/Password — When restoring local configuration, this option uses the IP address, user name and password that were automatically saved when you exited Managed mode. When restoring a saved configuration, this option uses the IP address, user name and password inside the saved configuration.
–Use Current IP/User Name/Password — When restoring local configuration, this option uses the system default IP address, user name and password.
–Apply Changes — The selected configuration is restored and the device reboots.
Booting the Device - Managed Mode
The procedure described in this section refers to the device when set to Managed mode. See Figure
In managed mode, the boot procedure can be monitored on the connected terminal as follows:
1Ensure that the device console port is connected to a VT100 terminal device or VT100 terminal emulator via the
2Locate an AC power receptacle.
3Deactivate the AC power receptacle.
4Connect the device to the AC receptacle.
5Activate the AC power receptacle.
When the power is turned on with the local terminal already connected, the device goes through Power On Self Test (POST). POST runs every time the device is initialized and checks hardware components to determine if the device is fully operational before completely booting. If a critical problem is detected, the program flow stops. If POST passes successfully, a valid executable image is loaded into RAM. POST messages are displayed on the terminal and indicate test success or failure.
6The boot process begins running in less than 45 seconds when in Unmanaged mode (and approximately 90 seconds when in other modes).
Initial Configuration Through the Set-up Wizard
To configure the device, it must be in Management mode.
NOTE: The switch is
In Management mode, you can configure the device in the following ways:
•Through the web management application (described in "Initial Configuration Through the Web" on page 48).
•Through the
44
NOTE: The initial simple configuration uses the following assumptions:
•The PowerConnect device was never configured before, and is in the same state as when you received it. Dell PowerConnect 28xx Systems User Guide