Dell 2900 owner manual E1A14

Table 1-6. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E1A14	SAS Cable A	SAS cable A is unseated, missing,	Check the cable connection to
		or bad.	the SAS backplane. See "Cabling
			the SAS Backplane Boards" on
			page 99.

E1A15	SAS Cable B	SAS cable B is unseated, missing,
		or bad.

Check the cable connection to the SAS backplane. See "Cabling the SAS Backplane Boards" on page 99.

E1A16	SAS Cable FB	Flex bay SAS cable is unseated,
		missing, or bad.

Check the cable connection to the SAS backplane. See "Cabling the SAS Backplane Boards" on page 99.

E1A17	Pwr Cable FB	Flex bay power cable is unseated,
		missing, or bad.

Check the power cable connection to the flex bay backplane. See "Installing the 1x2 Flex Bay Drive Bracket" on page 95.

E1A18	PDB Ctrl Cable	The power distribution board
		control cable is unseated,
		missing, or bad.

Ensure that the power distribution board control cable is seated properly. If the problem persists, replace the power distribution board control cable. See "Installing the Power Distribution Board" on page 112.

E2010	No Memory	No memory is installed in the	Install memory. See "Memory" on
		system.	page 82.
E2011	Mem Config Err	Memory detected, but is not	See "Troubleshooting System
		configurable. Error detected	Memory" on page 124.
		during memory configuration.
E2012	Unusable Memory	Memory is configured, but not	See "Troubleshooting System
		usable. Memory subsystem	Memory" on page 124.
		failure.
E2013	Shadow BIOS Fail	The system BIOS failed to copy	See "Troubleshooting System
		its flash image into memory.	Memory" on page 124.
E2014	CMOS Fail	CMOS failure. CMOS RAM not	See "Getting Help" on page 147.
		functioning properly.
E2015	DMA Controller	DMA controller failure.	See "Getting Help" on page 147.
E2016	Int Controller	Interrupt controller failure.	See "Getting Help" on page 147.

About Your System

23