Dell 2900 owner manual Installing the Power Distribution Board

Figure 3-34. Removing the Power Distribution Board

1 2

2

1 power distribution board 2 screws (5)

Installing the Power Distribution Board

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.

1Unpack the new power distribution board.

2Holding the power distribution board by its edges, carefully lower the board into the chassis and align the board with the fastener holes at the bottom of the chassis. See Figure 3-34.

3Using a #2 Phillips screwdriver, install the five screws to secure the power distribution board to the system chassis. See Figure 3-34.

4Attach the power cables to the power distribution board.

5Reinstall the system board. See "Installing the System Board" on page 109.

6Attach the cables from the power distribution board to the system board.

7Attach the cables from the power distribution board to the SAS backplane board.

112

Installing System Components