3Disconnect the FlexBay USB cable from the back of the Media Card Reader and from the internal USB connector on the system board (see "System Board Components" on page 65) and remove the cable from the cable routing clip.
1
2
3
1 drive latch release | 2 | sliding plate | 3 | Media Card Reader |
4Slide the drive latch release toward the bottom of the computer and, without releasing the drive latch release, slide the Media Card Reader out through the front of the computer.
5If you are not replacing the Media Card Reader, reinstall the drive panel insert, as needed (see "Replacing the
6Replace the drive panel (see "Replacing the Drive Panel" on page 84).
7Connect your computer and devices to electrical outlets, and then turn them on.
Removing and Installing Parts
97