Dell DCSM, PY349 owner manual Installing a Media Card Reader

Installing a Media Card Reader

NOTE: In the event that the replacement or new Media Card Reader does not have shoulder screws, use the screws located within the drive panel insert. Otherwise, reuse the screws attached to the card reader that you are replacing.

1

2

1 Media Card Reader 2 screws (4)

1Follow the procedures in "Before You Begin" on page 61.

2Remove the drive panel (see "Removing the Drive Panel" on page 81).

3If this is a new card reader installation:

•Remove the drive panel insert (see "Removing the Drive-Panel Insert" on page 83). Remove the four shoulder screws from the drive panel insert.

•Remove the Media Card Reader from its packaging.

•Remove the shoulder screws from the inside of the drive-panel insert and attach the screws to the new Media Card Reader.

4Gently slide the Media Card Reader into place until you feel a click or feel the drive securely installed. Ensure that the Media Card Reader is installed before the FlexBay cable is connected.

5Connect the USB cable to the back of the Media Card Reader and to the USB connector on the system board (see "System Board Components" on page 65).

98

Removing and Installing Parts