Dell E26S Series owner manual Installing an AC power supply unit

Figure 44. Removing and installing an AC power supply unit
1.	release latch	2.	power supply unit cable connector
3.	power supply unit	4.	connector

5.power supply unit handle

Installing an AC power supply unit

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Steps

1.Verify that the power supply unit being installed is of the same type and has the same maximum output power as the existing power supply unit.

NOTE: The maximum output power (shown in watts) is listed on the PSU label.

2.If installed, remove the power supply unit blank.

3.Slide the new power supply unit into the chassis until the power supply unit is fully seated and the release latch snaps into place.

NOTE: If you unlatched the cable management arm, re-latch it. For information about the cable management arm, see the system’s rack documentation.

4.Connect the power cable to the power supply unit and plug the cable into a power outlet.

CAUTION: When connecting the power cable, secure the cable with the strap.

106