Removing the hard-drive backplane
Prerequisites
1.Ensure that you read the Safety instructions.
2.Follow the procedure listed in Before working inside your system.
3.Remove all hard drives.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: To prevent damage to the hard drives and
CAUTION: You must note the number of each hard drive and temporarily label them before removal so that you can replace them in the same locations.
Steps
1.Disconnect the SAS/SATA/SSD data cable(s) and power cable from the backplane.
2.If applicable, disconnect the power/data cable from the optical drive.
3.Push the backplane blue release tabs in the direction of the arrows and lift the backplane upwards.
4.Pull the backplane away from the system until the securing slots on the backplane are free from the tabs on the chassis.
Figure 48. Removing and installing the 2.5 Inch (x8) hard-drive backplane
1. backplane | 2. backplane signal cable |
112
