For more information, see Installing the system cover.

2.Install the optional bezel.

3.Reconnect the system to its electrical outlet and peripherals.

4.Turn the system on, including any attached peripherals.

Recommended tools

You need the following tools to perform the removal and installation procedures:

Key to the bezel lock. This is only required when you have a bezel.

#2 Phillips screwdriver

#1 Phillips screwdriver

T6, T8, T10, and T15 Torx screwdrivers

The following tools are required for assembling cables for a DC power supply unit (PSU):

AMP 90871-1 hand-crimping tool or equivalent

Tyco Electronics 58433-3 or equivalent

Wire-stripper pliers capable of removing insulation from size 10 AWG solid or stranded, insulated copper wire

NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).

Front bezel (optional)

Removing the front bezel

1.Unlock the bezel lock at the left end of the bezel.

2.Lift the release latch next to the bezel lock.

3.Pull the left end of the bezel, unhook the right end and remove the bezel.

51

Page 51
Image 51
Dell E26S Series owner manual Recommended tools, Front bezel optional, Removing the front bezel