Figure 55. Removing and installing the control panel |
| |
1. | control panel | 2. notch on chassis front wall (2) |
3. | display module ZIF connector | 4. display module cable |
Installing the control panel–8 hard drive system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
Keep the #1 Philips screwdriver ready.
Steps
1.Slide the left side of the control panel into the chassis so that the left tab on the control panel aligns with the slot on the chassis wall and the top left tab aligns with the slot on the top of the chassis.
2.Pull the display module cable through the opening and into the chassis.
3.Push the right side of the control panel until the top right tab aligns with the top of the chassis and the panel snaps into place.
4.Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures the control module to the chassis.
121
