Dell GX200 manual Internal View, Inside the Chassis

2.Restart the system.

3.Enter System Setup. To do this, press <F2> when F2=Setup appears in the upper-right corner of the screen.

If the operating system begins to load into memory, allow the system to complete the load operation, shut down the system, and try again.

4.Restore the system configuration settings.

NOTE: If the system does not have an audio expansion card but does have an integrated audio controller, be sure that the Sound setting is On. If the system has an audio expansion card, be sure that the Sound setting is Off.

5.While in System Setup, perform the following steps to configure the system if it has an LS-120 SuperDisk drive:

a.Set Diskette Drive A and Diskette Drive B to Not Installed.

b.Set Secondary Drive 0 or Secondary Drive 1, as appropriate, to Auto.

c.Go to the second page and set Diskette to Off.

6.While in System Setup, reset the chassis intrusion detector under the System Security tab by changing Chassis Intrusion to Enabled, Enabled-Silent, or Disabled.

7.If no other changes are required in System Setup, press <Esc> and follow the menu directions to reboot the system and implement the changes.

8.Run the Dell Diagnostics to verify that the system is operating correctly.

Internal View

Figure 3 shows the chassis with the cover removed.

Figure 3. Inside the Chassis

1Drive in upper bay

2Internal drive cage

3Chassis intrusion switch

4Drive interface cable

5Expansion-card cage

6Security cable slot

7I/O ports and connectors

8AC power receptacle

9Padlock ring

10Power supply

11System board

12Drive interface cable

Front-Panel Inserts

Figure 4. 5.25-Inch Front-Panel Insert Removal (cutaway view through top of cover)