Back to Contents Page
Mini Tower Chassis — Removing and Replacing Parts: Dell™ OptiPlex™ GX200 Systems Service Manual
Overview | Drives |
Recommended Tools | System Power Supply |
Precautionary Measures | |
Internal Views | Riser Boards |
Computer Cover | System Board Components |
Front Bezel | Expansion Cards |
Eject, Power, and Reset Buttons | Memory |
Microprocessor/Airflow Shroud/Heat Sink Assembly | |
Control Panel | System Battery |
Chassis Intrusion Switch | System Board |
|
|
Overview
This section provides procedures for removing and replacing the components, assemblies, and subassemblies in the Dell OptiPlex mini tower chassis GX200 system.
Unless otherwise noted, each procedure assumes that the following conditions exist:
•You have performed the steps in "Precautionary Measures."
•You have removed the computer cover.
•You can replace or reinstall a part by performing the removal procedure in reverse order unless additional information is provided.
Recommended Tools
Most of the procedures in this file require the use of one or more of the following tools:
•Small
•Wide
•#1 and #2
•
Also, use a wrist grounding strap as explained in "Precautionary Measures."
Precautionary Measures
Before you perform any of the procedures in this file, take a few moments to read the following caution for your personal safety and to prevent damage to the system from electrostatic discharge (ESD).
CAUTION: FOR YOUR PERSONAL SAFETY AND PROTECTION OF THE EQUIPMENT
Before you start to work on the system, perform the following steps in the sequence listed:
1.Turn off the computer and all peripherals.
2.Disconnect the computer and peripherals from their electrical outlets. Also, disconnect any telephone or telecommunication lines from the computer. Doing so reduces the potential for personal injury or shock.
3.If you are disconnecting a peripheral from the computer or are removing a component from the system board, wait 10 to 20 seconds after disconnecting the computer from the electrical outlet before disconnecting the peripheral or removing the component to avoid
