If the AV device is not a DENON device, or if the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the DENON remote control included with this device.
nnRemembering remote control codes from other devices1 Press and hold POWER ON and ZONE/DEVICE ON for at least 3 seconds.
“SETUP” flashes twice on the remote control unit.
2 Use ui to display “LEARN” on the remote control unit and press
ENTER.
3 When “MODE?” appears on the
remote control unit, press the 
input source select button of the 
AV equipment that you want to 
store.
•You cannot store the remote control code in the AMP button.
4 When “KEY? ” appears on the remote control unit, press the button that you want to store.
•You cannot store the remote control code in the POWER ON,
POWER OFF, ZONE SELECT, SOURCE SELECT, MACRO, QUICK SELECT 1 – 3, BACK LIGHT and input source select button.
5 When “SEND ” appears on the remote control unit, place the remote control unit of the AV equipment face to face with main remote control unit (of this unit). Next, press and hold down the desired button (that you want to store) of the remote control unit of the AV equipment.
•When the button is correctly stored, “OK” flashes four times on the remote control unit.
•If the button is not correctly stored, “FAIL” flashes four times on the remote control unit. If this happens, perform step 4 again.
6
7 When you have finished storing the remote control codes, press POWER ON.
“SET” flashes four times on the remote control unit and the normal operation mode is restored.
•There are some remote control units that cannot be programmed, or even if they can be programmed, they may not operate correctly. If this happens, use the remote control unit supplied with the AV equipment to operate it.
•The operations of the programmed buttons override the preset memory. If you do not require the programmed buttons, erase the stored remote control codes to return to the initial settings (vpage 112 “Operating learning function”).
•The number of buttons that can be stored varies depending on the remote control unit used. If you have stored the maximum number of buttons allowed for the remote control unit, “FAIL” appears on its display.
Operating the main remote control unit
nnErasing stored remote control codesErasing the code by each button1 Press and hold POWER ON and ZONE/DEVICE ON for at least 3 seconds.
“SETUP” flashes twice on the remote control unit.
2 Use ui to display “RESET” on the remote control unit and press
ENTER.
3 When “LEARN” appears on the remote control unit, press ENTER.
4 When “MODE?” appears on the remote control unit, press the input source select button of the AV equipment that you want to erase.
5 Use ui to display “ONE?” on the remote control unit and press ENTER.
6 When “KEY?” appears on the remote control unit, press the button that you want to erase.
“RESET” flashes four times on the remote control unit and the normal operation mode is restored.
112