nnChecking the SIRIUS signal strength and radio

ID

1 Press STATUS until “SIGNAL” appears on the display.

The display will switch as shown below, depending on the reception conditions.

Display

Status

EXCELLENT

Signal strength is excellent

GOOD

Signal strength is good

WEAK

Signal strength is weak

NO SIGNAL

No signal

2 Adjust the position of the antenna until “SIGNAL: EXCELLENT” is shown on the display.

3 Press STATUS until the channel (example: “SR001”) is displayed.

4 Press TUNING d or TUNING f

and select channel 0 (SR000).

Channel No. and Sirius ID are alternately shown on the display.

SR000 SiriusID

************ Sirius ID

• Write your own SIRIUS ID for storage use.

Sirius ID :

The strength of both the SIRIUS satellite and terrestrial signals can be checked “Antenna Aiming” (vpage 81).

nnPresetting radio channels (Preset memory)

Your favorite broadcast channels can be preset so that you can tune them in easily. Up to 56 channels can be preset.

1 Tune in the broadcast channel you want to preset.

2 Press MEMORY.

3 Press SHIFT to select the block (A to G) in which to preset the channel (1 to 8 per block), then press CH +, CH – or 1 – 8 to select the preset number.

4 Press MEMORY again to complete the setting.

• To preset other stations, repeat steps 1 to 4.

NOTE

Preset channels are erased by overwriting them.

nnListening to preset channels

Press CH +, CH – to select the desired preset channel, then press ENTER.

• Preset channels can also be selected by pressing SHIFT (Block) and 1 – 8 (Channel).

You can also operate via the main unit. In this case, perform the following

operations.

Press TUNING PRESET, then turn SOURCE SELECT to select the preset

radio channel.

Tuning in radio stations

nnSearching categories

1 Press o p.

 

SR001

Hits

1

 

 

 

CAT :

Pops

 

 

 

Channel category

 

 

 

 

 

 

 

 

 

 

 

 

2 Use o p to select the category, to use ui to select the desired channel.

nnAccessing SIRIUS satellite radio channels directly

1 Press SEARCH.

2 Press 0 – 9 to input the channel. Example: Accessing channel “SR123”: Press 1, 2 and 3.

• If no button is pressed within several seconds, the channel automatically switches to the one whose number has been input.

3 Press ENTER to set that channel. Reception switches to the selected channel.

•“UPDATING” is displayed while the encording code is being updated.

•“SIRIUS UPDATING” is displayed when updating SIRIUS tuner firmware.

•Refer to “Troubleshooting” – “SIRIUS Satellite Radio” (vpage 136) regarding other messages.

34