nnManual EQDefault settings are underlined.
Use the graphic equalizer to adjust the tone of each speaker.
“Manual EQ” can be set when “MultEQ XT 32” setting (vpage 89) is “Manual”.
Setting items | Setting details |
|
|
Adjust CH | q Select the speaker tone adjustment method. |
Correct the tone of each | L/R : Adjust the tone of left and right speakers together. |
speaker. | Each : Adjust the tone of each speaker. |
| All : Adjust the tone of all speakers together. |
| w Select the speaker. |
| e Select the adjustment frequency band. |
| 63Hz / 125Hz / 250Hz / 500Hz / 1kHz / 2kHz / 4kHz / 8kHz / 16kHz |
| • Select the speakers you want to adjust when “L/R” or “Each” is |
| selected. |
| r Adjust the level. |
| |
Curve Copy | Yes : Copy. |
Copy “Audyssey Flat” curve | No : Do not copy. |
from MultEQ® XT 32. | “Curve Copy” is displayed after Audyssey® Auto Setup has been |
| |
| performed. |
Default | Yes : Reset to the defaults. |
The “Manual EQ” settings No : Do not reset to the defaults. are returned to the default
settings.
| AUDIO/VIDEO ADJUST | |
| nnDolby Volume | Default settings are underlined. | |
|
| |
Setting items | Setting details | |
Dolby Volume | ON : Enables the Dolby Volume function. | |
Automatically adjusts | OFF : Disables the Dolby Volume function. | |
the volume that varies |
| |
depending on the contents | • Store “Dolby Volume” for each source. | |
and input source and | ||
• When “Dolby Volume” is set to “ON”, you cannot set “Tone”, | ||
performs appropriate | ||
“D.COMP”, “DRC” (vpage 86, 88). | ||
corrections of the frequency | ||
• When “Dolby Volume” is set to “ON”, “MultEQ XT 32” (vpage 89) is | ||
characteristic. | automatically set to “OFF”. | |
| ||
| NOTE | |
| • If the playback level of a source you are listening to is high, the data | |
| compression volume will become higher when the Dolby Volume | |
| function is enabled. | |
| When you set “Dolby Volume” to “ON” from “OFF”, the original | |
| playback level is restored. It is recommended that you lower the volume | |
| once before changing the setting. | |
| • The Dolby Volume function cannot be used in the DIRECT or PURE | |
| DIRECT mode. | |
Volume Leveler | Low : Set the adjustment volume to the lowest level. Adjusts the volume | |
Adjusts the volume so that | of contents with extremely high and low volume to a constant volume. | |
the playback level between | Mid : Set the adjustment volume to the medium level. Adjusts the volume | |
different contents will be | of contents with higher and lower volume than the average volume to a | |
always constant. | constant volume. | |
| High : Set the adjustment volume to the highest level. Adjusts the volume | |
| of all contents to a constant volume. | |
Volume Modeler | Half : Corrects the frequency to a flat level to make listening easier for | |
Perform volume correction | playback with low volume. | |
for each frequency band. | Full : Corrects the frequency to a flat level to make listening easier at all | |
| times. | |
| OFF : Disables the Volume Modeler function. |
version Simple
version Basic
version Advanced
“Dolby Volume” settings are stored for each input source.
Information
Remote control operation | Move the cursor | Confirm the setting | Return to previous menu | 91 |
buttons | (Up/Down/Left/Right) |
| ||
|
|
|