Denon AVR-4311CI Parameter Check, Retrieving Audyssey Auto Setup settings

					Error messages
Select “SW Test Start” and then press ENTER.			Adjust the volume control on your subwoofer so that
2 Subwoofer level measurement begins.			3 the measured level is within the 72 to 78 dB range.
During measuring, a “Testing …” message is displayed.
The measured level appears on the level indicator after about				AUDYSSEY AUTO SETUP
3 to 5 seconds.				Subwoofer Level Matching	1 2 3 4 5 6
				Please adjust the level of your active subwoofer unit
	AUDYSSEY AUTO SETUP			so that the level Indicates approx. 75dB
				Stop
	Subwoofer Level Matching	1 2 3 4 5 6

Parameter Check

This function enables you to check the measurement results and equalizer characteristics after Audyssey Auto Setup.

1 Use ui to select “Parameter Check” and then press ENTER or p.

Please place the microphone at ear height at main listening position, then push ENTER.

SW Test Start

dB

Next

Enter RETURN Cancel

Start measurement Output test tone from subwoofer

Blue 73.9dB

Enter

Change from red to blue when level matches

•If the measured level is within the 72 to 78 dB range, the level indicator is blue.

PARAMETER CHECK

Spkr Config Check

Distance Check

Ch. Level Check

Crossover Check

EQ Check

Restore

Check auto setup measurement results

AUDYSSEY AUTO SETUP

Subwoofer Level Matching 1 2 3 4 5 6

Please adjust the level of your active subwoofer unit so that the level Indicates approx. 75dB

Stop

Red 79.1dB

Enter

Change from red to blue when level matches

•If the measured level is outside the 72 to 78 dB range, the level indicator is red.

•When measuring stops, press ENTER.

4 When the measured level is within the 72 to 78 dB range, press ENTER.

Select “Next” and then press ENTER.
5 Proceed to “Set up speakers (Audyssey® Auto Setup),
STEP2 Detection & Measurement		” (vpage 9), 6 – w.
	AUDYSSEY AUTO SETUP
	Subwoofer Level Matching	1 2 3 4 5 6
	After adjustment, push “Next”.
	SW Test Start
	dB
	Next
	Enter	RETURN Cancel
	Proceed to next measurement

2 Use ui to select the item you want to check, then press ENTER or p.

Measurement results for each speaker are displayed.

	Check the speaker configuration.
Speaker Config Check
	Check the distance.
Distance Check
	Check the channel level.
Ch. Level Check
	Check the crossover frequency.
Crossover Check
	Check the equalizer.
EQ Check

•If “EQ Check” is selected, press ui to select equalizing curve

(“Audyssey” or “Audyssey Flat”) to be checked, and then press

ENTER or p.

Use ui to switch the display between the different speakers.

3 Press RETURN.

When you use two subwoofers, adjust each subwoofer so that the volume levels of Subwoofer 1 and Subwoofer 2 are appropriate for your needs.

The confirmation screen reappears. Repeat steps 2.

Retrieving Audyssey Auto Setup settings

If you set “Restore” to “Yes”, you can return to Audyssey Auto Setup measurement result (value calculated at the start by MultEQ® XT 32) even when you have changed each setting manually.

12	Remote control operation	Move the cursor	Confirm the setting	Return to previous menu
	buttons	(Up/Down/Left/Right)